Run a mini wash and place the hose into a bucket to see if water is coming out.
Electrolux washer no water message.
Check the little filter screens where the fill hoses connect to the back of the washer.
Pressure switch checks good.
This video provides step by step repair instructions for replacing the water inlet valve on an electrolux washing machine.
If not then something was setup wrong like a plug not being removed.
I tried a hard reset and spin only and it did the usual couple turns of the barrel here and there drain pump ran almost constant and taps out.
Replace the pressure sensor.
Replace the main control board.
Turn the water off and remove the hoses from the back of the washer.
Did the water fill stop.
There is a sensor stating no water is passing it.
Sometimes you can hear water gurgle out sometimes you can t.
You can hear the drain pump running.
If they are clogged flush them out.
If the compartment or inserts are stained allow them to soak in 3 4 cup of liquid bleach and a gallon of hot water before rinsing.
Remove power from the washer.
Place a bucket or other similar container under the tap.
Pressure switch checks bad.
You should be able to fill a 10 litre bucket in about a minute.
If this does not help and the error code reappears the inspector of the laundry must be contacted.
Disconnect the fill hoses from the back of the washer and put them in a 5 gallon bucket.
Taps out to e21 after a few minutes of that.
The most common reasons for replac.
Replace the inlet valve assembly.
The error code is displayed if the user presses the start button while the vacuum switch is already closed.
Replace the pressure switch.
Go to step 7.
Water leak in tub or air leak in air bell.
Remove some of the clothes close the door and press the start button.
Turn the water on to make sure you have good water pressure from both hot and cold water lines.
Remove the detergent compartment and take out the inserts then rinse them thoroughly under hot tap water to wash away residue and buildup.
Please register to post and access all features of our very popular forum.
If everything checks good you just need to replace your electronic water valve because it has failed and isn t letting any water into the washer.
Clean the filter in the inlet hose next to the tap.
Pull out the dispenser drawer and press down on the rear lock tab.
If this did not correct the problem go to step 7.
If there is a filter in the water valve where the inlet hose screws into the washing machine it should be also clean.
You ll need to pull the washer forward and turn the water off to the washer.
If it s time to repair your electrolux washing machine then it s time to consult repair clinic for the troubleshooting help you need.
Turn on the tap and check that enough water comes out of it.
